Installation Guide

1.) Thoroughly clean frame with degreaser, ideally isopropyl alcohol so there is NO residue.

2.) Peel away paper backing and apply to frame. (Refrain as much as possible from peeling off to adjust)

3.) Use a roller (paint can or tape roll works) with very firm pressure to push bubbles out and activate the adhesive

4.) Just like with installing graphics, heat is your friend. Although not required, it makes installation easier and you will guarantee a rock solid bond by heating the tape and rolling.

 

**Rubber will melt with a heat gun**

**DO NOT INSTALL TAPE IN COLD WEATHER, the adhesive only activates around room temperature**